3 common faults and repair methods of electric skateboards

When using an electric skateboard, there are always various reasons that cause the electric skateboard to stop working. Like any electronic device, electric skateboards sometimes go out of work without warning. Maybe you haven't encountered this situation yet, but you can reserve some necessary knowledge to deal with the situation where the electric skateboard cannot start. Let's take a look at some of the more common problems that cause the skateboard to not work properly.

In order to find a solution, you must first know which part of the electric skateboard has a problem. Pay attention to its symptoms.

If you can't turn on the skateboard, it may be that the battery is damaged.

If you have speed swings during riding, it may be a problem with your truck

If the remote control cannot be connected, it may be that the battery is dead or there is a problem with the connection with the skateboard.

What are the common problems with electric skateboards and how to solve them?

Electric skateboards are powered by electricity and are a type of electric vehicle. If they are used for a long time or used improperly, some problems and failures are inevitable. Common electric skateboard failures are mainly:

1. Electric skateboard cannot start

If your electric skateboard cannot start, it may be due to water damage or short circuit of the battery. You can try to charge it for 30 minutes and then start it again. If there is still no response, you should send it for repair or check the manufacturer's official website for a solution.

Battery damage: You can check that the electric skateboard can be turned on while charging by plugging it into a charger. In this case, the most likely problem is the battery, and the battery of the skateboard needs to be replaced.

Line power failure: If it cannot be started even when charging, it may be due to line power failure and other situations, and it needs to be sent for repair.

Water in the skateboard: The chassis of the battery skateboard is low, and it is easy for water to enter the chassis when riding in rainy days or wading, causing damage to other parts such as the controller and battery. This kind of fault is difficult to solve by yourself, and usually requires a specialist to repair it.

2. Loud riding noise

It may be that something is stuck in the brake system, or the belt tension causes noise. This task is quite complicated because you need to remove the motor cover to readjust the belt. A special tool kit is required and the manufacturer's instructions are carefully checked. This situation is generally caused by the lack of phase in the motor. Most controllers are now intelligent, and zero-starting due to lack of phase will vibrate. Another possibility is that there is a problem with a phase line circuit inside the controller. After carefully checking whether there is a problem with the connection line, if the Hall and connection lines are detected normally, then the internal components of the controller have failed and the controller needs to be replaced.

3. It can start normally but stops after running a few meters

The skateboard cannot run

The power is insufficient and the controller enters the undervoltage protection state.

The line contact is poor, and the power is cut off due to "obstruction" caused by the increase in speed and current, indicating that there is a problem of poor welding.

Controller problem, the internal components of the controller are damaged or the internal components are poorly welded, and the controller needs to be replaced.

The above only lists three common types of electric skateboard failures and solutions. What other failures have you encountered? Did you send it to the store for repair or did you study and repair it yourself? Friends can contact us through E-mail sales2@cnpiaoma.com or WhatsApp: +8618869935053